When measuring phase angle between two waves using a CRO, the time base generator is connected to

When measuring phase angle between two waves using a CRO, the time base generator is connected to
1). X plane
2). Y plane
3). Both X and Y plate
4). Neither X nor Y plates

---

Join Telegram Group

Answer This Question
Name:
Email:
Answer :
Sum of (4+4)
Submit:

Other Questions

1. The insulating material for cables should

2. The power factor at resonance in R-L-C parallel circuit is

3. In D.C. machines, the ________ in field mmf results in increase in size and cost of machines.

4. The application where one would most likely find a crystal oscillator is ___________

5. What is the delay time for satellite transmission from earth transmitter to earth receiver?

6. Twelve volts are applied across a resistor. A current of 3 mA is measured. What is the value of the resistor?

7. Which of the following capacitors is polarized?

8. Shunt generators are most suited for stable parallel operation because of their

9. Skip distance depends on time of day and angle of incidence.

10. An RL low-pass filter consists of a 5.6 mH coil and a 3.3 kΩ resistor. The output voltage is taken across the resistor. The circuit's critical frequency is