The inters heaths in the cables are used to

The inters heaths in the cables are used to

A).  Minimize the stress

B).  Avoid the requirement of good insulation

C).  Provide proper stress distribution

D).  None of the above

---

Join Telegram Group

Answer This Question
Name:
Email:
Answer :
Sum of (5+5)
Submit:

Other Questions

1. Which meter is suitable for the measurement of 10mV at 50MHz?

2. In a parallel LC circuit, if the input signal frequency is increased above resonant frequency then ___________

3. With three resistances connected in parallel, if each dissipates 20 W the total power supplied by the voltage source equals

4. The property of a material which opposes the creation of magnetic flux in it is known as

5. For an oscillator to properly start, the gain around the feedback loop must initially be

6. A switch has ___________.

7. In Bode plots the frequency at which two asymptotes meet is called corner frequency.

8. An electric heater draws 3.5 A from a 110 V source. The resistance of the heating element is approximately

9. In a loaded Zener regulator, which is the largest Zener current?

10. Hard steel is suitable for making permanent magnets because