The pressure coil of a wattmeter should be connected on the supply side of the current coil when

The pressure coil of a wattmeter should be connected on the supply side of the current coil when

A).  Load impedance is high

B).  Load impedance is low

C).  Supply voltage is low

D).  None of the above

---

Join Telegram Group

Answer This Question
Name:
Email:
Answer :
Sum of (3+1)
Submit:

Other Questions

1. A rheostat differs from potentiometer in the respect that it

2. When a number of components are fabricated on same IC chip it is necessary to provide isolation between two different components for input interconnection is called __________.

3. Which of the following instruments indicate the instantaneous value of the electrical quantity being measured at the time at which it is being measured ?

4. The modern steam turbines are

5. In _________ method of staging three phase induction motors the starting voltage is not reduced.

6. The total losses in a well designed D.C. generator of 10 kW will be nearly

7. Two coils have inductances of 8 mH and 18 mH and a coefficient of coupling of 0.5. If the two coils are connected in series aiding, the total inductance will be

8. Magnetic circuit breaker has ______ trip action.

9. In a 3-phase power measurement by two wattmeter method the reading of one of the wattmeter was zero. The power factor of the load must be

10. In ______ system the charging current is intermittently controlled at either a maximum or minimum value