In pneumatic control systems the control valve used as final control element converts

In pneumatic control systems the control valve used as final control element converts

A).  Pressure signal to electric signal

B).  Pressure signal to position change

C).  Electric signal to pressure signal

D).  Position change to pressure signal

---

Join Telegram Group

Answer This Question
Name:
Email:
Answer :
Sum of (5+5)
Submit:

Other Questions

1. The 'crawling' in an induction motor is caused by

2. When a rectangular voltage waveform is applied to a capacitor, then the current waveform is ___________.

3. The open circuit voltage of a compound generator is 250 V. At full load the terminal voltage

4. In the case of an unsymmetrical alternating current the average value must always be taken over

5. In a p-channel JFET, the charge carriers are ___________

6. To limit short-circuit current in a power system are used

7. The capacitance C is charged through a resistance R. The time constant of the charging circuit is given by

8. The arc voltage produced in A.C. circuit breaker is always

9. Tractive magnets are operated from

10. By which of the following methods the constant speed of a synchronous motor can be changed to new fixed value ?